MOSQUITO MK1 FULL KIT (LIMITED RUN)
Please note that no gearbox or battery is supplied due to the risks of mailing them to different countries.
Once this set runs out, I will not do it again due to difficulties in sourcing and managing airsoft components.
PLEASE ALLOW FOR AT LEAST 1-2 WEEKS LEAD TIME DUE TO HIGH VOLUME OF 3D PRINTED PARTS
---
For more information on the MOSQUITO MK1, click here.
What's included?
- All original MK1 release 3D printed parts
- All components, screws and nuts etc
- Airsoft parts: inner barrel, hop-up bucking, hop-up nub, and 1x long magazine
This kit includes everything required to assemble all variants of the MOSQUITO MK1 airsoft platform, except the gearbox and battery.
Parts will be printed in PLA+. This material has been tried and tested in games and against impacts
The chosen inner barrel length may vary a little bit depending on stock levels. The short inner barrel will be between 128-150mm, and the long inner barrel will be between 240-250mm.
If you plan to use the longer barrel and suppressor configuration, select the longer inner barrel. If you prefer the short handguard and barrel setup, select the shorter inner barrel, but it will not be compatible with the longer battery suppressors. Please note that only one inner barrel length can be supplied per kit.
If you are opting for a customised colour scheme, select "Custom" and email me at the address below to discuss your details:
jon@hybrid-armory.com
